Since the network ports of PC0 and PC1 are connected to the VLAN10, you will see that there is a connection when you ping between these computers. SWITCH(config)# interface fastethernet 0/6ДЄfter adding the Switchport to the VLANs, check the interfaces you have created and made on the Switch with the show vlan command. SWITCH(config-if)# switchport access vlan 30 SWITCH(config)# interface fastethernet 0/5 To assign clients in the green zone to the VLAN20, perform the following commands in order. SWITCH(config)# interface fastethernet 0/4 SWITCH(config-if)# switchport access vlan 20 SWITCH(config)# interface fastethernet 0/3 To assign clients in the blue zone to VLAN20, perform the following commands in order. SWITCH(config)# interface fastethernet 0/2

SWITCH(config-if)# switchport access vlan 10 SWITCH(config-if)# switchport mode access SWITCH(config)# interface fastethernet 0/1 To assign clients in the red zone to VLAN10, perform the following commands in order. Switch from privileged configuration mode on Cisco Switch to global configuration mode. Switch# conf tДЄfter creating VLANs for departments, you need to make clients connected to the Switch interface to VLANs. Use the following commands to create a VLAN by topology. To change to Privileged mode, execute enable.ДЄfter making the basic settings, create 3 different VLAN groups according to the topology you have created on the Switch. First, add a Router, Switch, and six PCs to the Packet Tracer workspace to create a network topology as shown in the image below.ДЄfter configuring the Cisco RouterвЂ™s interface and the TCP/IP settings of the computers, click Switch and click the CLI tab in the window that opens.

Configure vlan cisco switch